Custom Mount for Ammo Case Storage in Step Through - RadRunner Plus

[blueprintprinting]

So I just finished up my custom designed mount to attach an ammo case in the step through. I liked the idea of the Rad Center Console but I didn't want to lose the step through. So I fired up Fusion360 and my 3D printer. I went through a lot of iterations of this design until I found one that worked well. It takes a couple hours to print and uses more plastic than some other iterations but it is much easier to mount and makes a firmer connection. This is just one of many mods I've made so far. Some others are: raising the passenger seat by any inch with nylon spacers to make room to store my cable and ulock; printing a thumb throttle; adding side mirrors and turn signals; mounting a anti-theft vibration alarm under the passenger seat; custom vinyls to blackout the Rad branding. Happy to answer any other question

On to the photos



I use it to store my pump and tools. Also could throw in my phone and wallet for longer rides.


Secured by a Master Lock, which will only keep honest people honest.


View of the Ammo Case and Mount off the bike


The mount alone



Not sure if this is allowed but I am selling them on Etsy if anyone wants one. Comes with the mount and mounting hardware but you have to buy the ammo case off Amazon because I can't afford to ship that without insane markup.
https://www.etsy.com/listing/1266939998/radrunner-plus-ammo-case-mount-center

[AtLarge]

Nice job!

[Si1Dia]

LOVE IT !!!!!!

[swannlv]

Hello! How do you make those vinyls? Thanks! ^^

[blueprintprinting]

Hello! How do you make those vinyls? Thanks! ^^

I designed them in illustrator and cut them out on my Cricut.