New error message

[Count]

I completed some mods and went to turn on my bike, and got a "Motor position sensor fault", and nothing works.  I have not seen this or have not read about it. Any ideas?

[Altema]

Check configuration setting P2 on the new controller display (Wheel Speed Pulse Signal Setting Mode (number of sensor magnets), 0-6).
The stock 750 watt Rad motor has 5 sensor magnets, but I'm not sure how many your new motor has. If you do know how many sensor magnets are in the new motor, make sure P2 matches that. Otherwise, it would be best to contact Electro Bike World.

[Count]

Thanks!  I was told to consider treating it like an Error 24, but that did not help. I will contact EBW today!